Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Blue

LMS 3.1 reporting of CatOS switch ports

The goal is to get a full list of "connected"/"in use" Ethernet ports on the network. However, I cannot seem to find any way to have RME produce on a list of CatOS switch ports, because the only pertinent option available is "Interface" which as I feared reports IOS switch ports only. Am I missing something?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.1 reporting of CatOS switch ports

This is not available in RME. The Interfaces custom report option does not include the module port interfaces. The only way to get this data is to use Campus Manager, and run the Port Attributes report. This will give you all ports, but this can be sorted on the operationally up ports.

There is still a bug open, CSCsj78780, to get all of the available attributes added to RME custom reports.

1 REPLY
Cisco Employee

Re: LMS 3.1 reporting of CatOS switch ports

This is not available in RME. The Interfaces custom report option does not include the module port interfaces. The only way to get this data is to use Campus Manager, and run the Port Attributes report. This will give you all ports, but this can be sorted on the operationally up ports.

There is still a bug open, CSCsj78780, to get all of the available attributes added to RME custom reports.

113
Views
0
Helpful
1
Replies