Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.1 to 3.2 upgrade

We have 2 LMS 3.1 systems running in a Master-Slave configuration and want to upgrade to LMS 3.2. Is there any preference as to which system should be upgraded first, or does it matter? I could not find anything in the Data Migration guide regarding Master-Slave configurations. Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: LMS 3.1 to 3.2 upgrade

You should upgrade the Master server first. After that has been successfully completed, you should restart daemon manager on the slave prior to upgrading it.

Hope this helps.

3 REPLIES
Hall of Fame Super Silver

Re: LMS 3.1 to 3.2 upgrade

You should upgrade the Master server first. After that has been successfully completed, you should restart daemon manager on the slave prior to upgrading it.

Hope this helps.

New Member

Re: LMS 3.1 to 3.2 upgrade

Yes that helps very much, thank you.

Out of curiosity, is there any place where that is documented?

Hall of Fame Super Silver

Re: LMS 3.1 to 3.2 upgrade

A nod to our resident Cisco expert, Joe Clarke, for the original answer to this question - it was covered in an earlier posting: http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cd358f6/0#selected_message

The procedure is also documented (albeit briefly) in the "Installing and Getting Started with CiscoWorks LAN Management Solution 3.2" document. The relevant section is here: http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/install/guide1/overview.html#wp1086033

Hope this helps.

191
Views
0
Helpful
3
Replies