Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.1 - Understanding UT-History Report

Hello,

I just discovered an intresting behavior of UT-Reports.

Generating a endhost-report with CM:UT>Reports and selecting appropriate filter endhosts from last UT-disco cycle will be shown. Devices not seen during these discovery, but some time before will only be shown in UT-History-Report (CM:UT>Reports>Report Generator>Application=History,Report=End Host History).

Is that true that standard end-host-report only shows devices seen in last UT-Disco cycle?

Unfortunately I couldn't find any doc about this.

Thanks for an clarification.

Lothar

1 REPLY
Cisco Employee

Re: LMS 3.1 - Understanding UT-History Report

The end host report will show all end host records regardless of when they were last seen in the network. Of course, this depends on your delete interval settings. If you are deleting all old end host data aggressively, then what you're seeing is probably expected. Also, if you are running an end host custom report, your custom report settings could be filtering out old end host data.

117
Views
0
Helpful
1
Replies
CreatePlease to create content