I am using LMS 3.2.1, and while deploying the configuration to the device via Netconfig job, I receive below error message. All commands deploy successfully but Netconfig job status always failed because of below error message;
Command(s) failed on the device TFTP: Failed on the device.
However I can sync archive the same devices successfully.
Transport Settings->Archive management = SSH TELNET TFTTP RCP
Transport Settings->Config Deployment = SSH TELNET TFTTP
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.