Can anyone tell me if I need a seed devices to add devices manually or can I just bypass this portion of the setup since I'm NOT going to be discovering anything with Ciscoworks.(My envoronment is to complex to perform and discovering) Or do I need a seed device anyhow for functionality of Ciscoworks and other processes?
Thanks Nael, Your answer is sufficient. The document by Joe is good and I have reviewed it in detialed by it does not reference anything about my question, but he does go over everything else in the discovery section of the install.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...