LMS 3.2 and Windows 2008 R2

[Marc ZANUTTINI]

Hi everybody,

Does anyone know if LMS 3.2 is supported under Windows 2008 R2 version ? (Information isn't clearly mentioned in the documentation).

Thanks

Marc Zanuttini

[Joe Clarke · Accepted solution]

No, it is not.  There are known issues with DFM and Windows 2008 R2.  Windows 2008 SP1 and SP2 are supported on 32 and 64-bit systems, but R2 is not supported.

--

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com

[Marc ZANUTTINI]

Thanks very much for the reply.

I'll wait for a new version of LMS if I want to install the Windows 2008 R2 release.

Marc

[Chris McGarrah]

I know this is a very old thread but is there any way to install LMS3.2 on Windows 2008 R2 if DFM is not installed/used. We do not use DFM for fault management anyway.  Is there some way to bypass the check?

Thanks in advance.

[Marvin Rhoads]

There's no option to bypass the compatibility checks when installing on Windows.

Even if you could, any device that began to be manufactured in the last 4 years (more or less) will not be supported by LMS 3.2.

You'd really be much better off with a current solution.