Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LMS 3.2 and Windows 2008 R2

Hi everybody,

Does anyone know if LMS 3.2 is supported under Windows 2008 R2 version ? (Information isn't clearly mentioned in the documentation).

Thanks

Marc Zanuttini

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.2 and Windows 2008 R2

No, it is not.  There are known issues with DFM and Windows 2008 R2.  Windows 2008 SP1 and SP2 are supported on 32 and 64-bit systems, but R2 is not supported.

--

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com

4 REPLIES
Cisco Employee

Re: LMS 3.2 and Windows 2008 R2

No, it is not.  There are known issues with DFM and Windows 2008 R2.  Windows 2008 SP1 and SP2 are supported on 32 and 64-bit systems, but R2 is not supported.

--

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com

New Member

Re: LMS 3.2 and Windows 2008 R2

Thanks very much for the reply.

I'll wait for a new version of LMS if I want to install the Windows 2008 R2 release.

Marc

New Member

I know this is a very old

I know this is a very old thread but is there any way to install LMS3.2 on Windows 2008 R2 if DFM is not installed/used. We do not use DFM for fault management anyway.  Is there some way to bypass the check?

Thanks in advance.

Hall of Fame Super Silver

There's no option to bypass

There's no option to bypass the compatibility checks when installing on Windows.

Even if you could, any device that began to be manufactured in the last 4 years (more or less) will not be supported by LMS 3.2.

You'd really be much better off with a current solution.

626
Views
0
Helpful
4
Replies