Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.2 Archiving Partially successful

Hi,

We have installed LMS 3.2,But for some of the switches archiving is partially successfull.Switches are 6500 in transparent mode.We use ssh for archive management.dcmaservice Log says...

[ Thu Jan 21  14:51:05 AST 2010 ],ERROR,[Thread-1540],com.cisco.nm.xms.xdi.transport.cmdsvc.LogAdapter,error,19,Unknown authentication method: keyboard-interactive.In the RME I can see the log as Command Failed.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.2 Archiving Partially successful

For 6500s, the command is:

copy const_nvram:vlan.dat tftp:

Even though you may be in transparent mode, you may still have an old vlan.dat file in const_nvram:.  If so, delete it, and this error should go away.

9 REPLIES
Cisco Employee

Re: LMS 3.2 Archiving Partially successful

Exactly which configuration is failing?  A device can have up to three different configurations: RUNNING, STARTUP, VLAN.  The failing configurations will dictate the next troubleshooting step.

New Member

Re: LMS 3.2 Archiving Partially successful

Hi Clark,

Actually its Vlan Configuration.

[ Thu Jan 21  14:51:43 AST 2010 ],ERROR,[Thread-1540],com.cisco.nm.rmeng.dcma.configmanager.ConfigManager,updateArchiveForDevice,1355,VLAN RUNNING Config fetch Failed for 10.10.0.1

Startup and running configuration is successful.

Cisco Employee

Re: LMS 3.2 Archiving Partially successful

For RME to be able to fetch the VLAN config, it must be able to copy the vlan.dat file from flash back to itself using TFTP.  RME will issue a command similar to:

copy flash:vlan.dat tftp:

Make sure the device can properly copy the vlan.dat back to the RME server using TFTP.

New Member

Re: LMS 3.2 Archiving Partially successful

The switch is in transparent mode,does not have the vlan.dat file on flash.

Cisco Employee

Re: LMS 3.2 Archiving Partially successful

What version of code is this switch running?  What type of switch is it?

New Member

Re: LMS 3.2 Archiving Partially successful

We are having 12 WS-C6509-E switches running the ios Version 12.2(33)SXH4 giving this partially successful error.

Cisco Employee

Re: LMS 3.2 Archiving Partially successful

For 6500s, the command is:

copy const_nvram:vlan.dat tftp:

Even though you may be in transparent mode, you may still have an old vlan.dat file in const_nvram:.  If so, delete it, and this error should go away.

New Member

Re: LMS 3.2 Archiving Partially successful

thanks clarke,I will try this remedy tomorrow and let you know.

New Member

Re: LMS 3.2 Archiving Partially successful

Got it clark,I have deleted the old vlan.dat file and now its working fine.Thank you very much for your support.

452
Views
0
Helpful
9
Replies
CreatePlease login to create content