LMS 3.2. Campus Manager (5.2.1) and some devices in "Not Managed" state
I have enabled auto mode and manually included but when I run a data collection some devices don't take part in the process. When I click in show included devices I can see 13 devices in Not Managed state, include C2950G and C2960S . But 3 sets of C2950G can be managed . What is this? How can I fix it?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...