Two switches, which are not configured for SSH and snmvp3, were picked up during an discovery and automatically added to the DCR. When I view the list of devices in the DCR the two devices are shown, but when I try to edit the DCR to remove/delete the two devices they are no where to be found. Has any one else encountered this?
Sounds like this server may be integrated with ACS. If that is the case, the devices should be seen under Common Services > Device and Credentials > Reports > Devices not configured in ACS. If you see them there, you have two choices. The first is to either add those devices at network clients to ACS (temporarily). Then you will be able to see them in the DCR Device Management screen and delete them from LMS. Or, you can temporarily break integration with ACS, restart Daemon Manager, clean up DCR, and re-enable ACS integration.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...