I am facing a problem with my LMS 3.2 server. Suddenly I found there is no device reflecing in common services-> device management as well as RME also. I restarted LMS services, server multiple time, reseted casuser, demoted the server from ACS mode to local mode but no luck. However in "dcrcli" i can see all devices and exported all devices to CSV file.
After this I restored from a backup 3 month old when devices were reflecting under common server and RME device management. this also not resolved the problem.
I uninstalled LMS, performed system cleaning and reinstalled LMS 3.2. Then I imported the devices from CSV file i had. Now also the problem not got resolved . I can see devices in dcrcli but none of the device is reflecting under device management of any module.
In Dcmaservice.log i found the error" ERROR,[main],com.cisco.nm.rmeng.config.netshow.server.admin.NSCommandSetManager,getAllCommandSet,8661,Invalid MDF data file:D:/CSCOpx/lib/classpath/com/cisco/nm/cwcs/mdf/mdfdata.xml"
Hence I restored teh mdfdata.xml file from another server. However now i can see the following errors
1) in common service -> software center -> device updae -> device count are 0 for all module
2) no device is reflecting under any module
3) one progress i saw when tring to add any device if selecting device type, it is showing me the list of device type along with OID. before restoring mdfdata.xml it was also not comming.
"I uninstalled LMS, performed system cleaning and reinstalled LMS 3.2. Then I imported the devices from CSV file i had. Now also the problem not got resolved . I can see devices in dcrcli but none of the device is reflecting under device management of any module."
Is it correct, that you made a fresh install of LMS and you just imported your devices from a csv file and they do not show up in CS > Device and Credentials > Device Management? or you cannot see them in other applications like RME, CM etc?
if the errors shown in dcmaservice.log belongs to this fresh installation, I would assume that your installation went wrong in the first step. Can you post the installation log from this installation along with the log of the LMS 3.2.1 installation -if you have installed it also (located in C:\); Please provide the output of the following DOS commands also: set systeminfo when dmgtd is running netstat -nabo when dmgtd is stopped netstat -nabo
Does this server belongs to a domain? What other sofware is running on this server (Backup-SW, Anit-Virus,other management tools)
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...