Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.2 - configuring IPM

Hi!

Can anyone assist me with configuring IPM?

(describe in few steps how to set things up)

I have a ring network (running OSPF) and I would like to monitor delay  and availability on optical lines connecting these devices. I would also like to monitor critical devices (6500VSS for example...).

Which is the simplest way to configure these IPM monitors and how are they used?

Thank you for your help!

1 REPLY
Cisco Employee

Re: LMS 3.2 - configuring IPM

IPM will configure the IP SLA feature on the source device (most IOS devices with an image better than IPBASE will be fine).  IPM is not very involved.  You will generally work from left to right under IPM > Collector Mgmt.  Consult the context-sensitive online help for specific details.

The most basic thing you can do is an ICMP echo operation from a single source device to multiple targets.  This doesn't require anything special to be configured on the target devices (besides IP).  On the source device, you only need valid SNMP read-write credentials configured with matching values in DCR.

258
Views
0
Helpful
1
Replies