Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.2 logs "Died method called for process..."

This is a new LMS 3.2 installation on Windows Server 2003 SP2

We are continually seeing messages in the syslog that looks like a process attempting to start then die. (sample of messages attached and pdshow output)

Nothing is obviously wrong at this stage but I haven't gone through and checked ALL functionality.

Anyone seen these messages before and/or give any pointers to start troubleshooting?

Thanks in advance, Graeme

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.2 logs "Died method called for process..."

This is perfectly fine.  Each job that is run is registered as a Daemon Manager controlled process.  The job will run, terminate, then get unregistered.  As you run pdshow, you may periodically notice daemons whose name is a number.  These are jobs, and the number is the job ID.

1 REPLY
Cisco Employee

Re: LMS 3.2 logs "Died method called for process..."

This is perfectly fine.  Each job that is run is registered as a Daemon Manager controlled process.  The job will run, terminate, then get unregistered.  As you run pdshow, you may periodically notice daemons whose name is a number.  These are jobs, and the number is the job ID.

551
Views
0
Helpful
1
Replies