I have an issue with HUM 1.2.1. I have deleted a device in Common Services, Device Management. The problem is that there was a poller configured with this device in HUM. I am now unable deleting the poller.
Re: LMS 3.2: problem with HUM due to device deleted
OK I will try it.
Just to give more information :
The first problem was that in DFM the device stayed in learning state. I tried to increase timeout, delete the device, rediscover it, ... But the device still in learning state.I notice a thread talking about possible problem with the SNMP engineID. I configured the device with a new SNMP engineID, and deleted it using Common Services/Device Management.
And the problem with HUM appeared ...
I have already rediscovered the device with his new SNMP engineID. All is working in RME and in Campus Manager. The problem still the same in HUM.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.