Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

LMS 3.2 - RME configuration archive

we have created a lmsadmin username in the ACS with privige access (authorization configuration) only. This username is used to take config archives from all the network devices.

But archive is getting failed in our firewall. When we give full access in ACS for lmsadmin (conf terminal access), it works for firewall.

As per our policy, we are not supposed to provide conf access to this user name.

Please suggest.

Regards,

Guru

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.2 - RME configuration archive

In order for RME to archive the config from FWSM devices, it must be able to run the following commands:

show running

show config

show curpriv

conf t

terminal width 0 (within config mode)

terminal no monitor

Therefore, you will need to grant the RME user access to enter config mode.

3 REPLIES
Cisco Employee

Re: LMS 3.2 - RME configuration archive

In order for RME to archive the config from FWSM devices, it must be able to run the following commands:

show running

show config

show curpriv

conf t

terminal width 0 (within config mode)

terminal no monitor

Therefore, you will need to grant the RME user access to enter config mode.

Community Member

Re: LMS 3.2 - RME configuration archive

Thanks for your response.

So this is applicable for any firewall device (PIX and ASA)?

Regards,

Guru

Cisco Employee

Re: LMS 3.2 - RME configuration archive

Yes.

196
Views
0
Helpful
3
Replies
CreatePlease to create content