Re: LMS 3.2 showing IP instead of SYSNAME in emails
unfortunately there is no option to make the sysname to be the display name, you can achive this only by name resolution...
the bestwould be to enable name resolution for the devices, i.e. add your devices to DNS or maintain a hosts file on your server. If you have done this be sure to have the following setting for discovery marked: Update DCR Display Name
With DFM it is a little bit different, - you have to delete them from DFM and rediscover all devices
I think it should also be possible to enter a custom display name through CS > Device and Credentials > Device Management but DFM would not take account of this setting.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...