Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3 -ipa sla

Hi,

While configuring the source router, the ip sla monitor command requires additional commands.

Where can i can find the exact command

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3 -ipa sla

Yes, SNMPv3 is supported. It would help to see the configuration and show ver from this device.

3 REPLIES
Cisco Employee

Re: LMS 3 -ipa sla

What exactly do you want to do? If you're using IPM, then IPM will do all of the setup for you. All you need is SNMP read-write credentials on the device. The only thing you may want to configure is the IP SLA responder. That command is simply:

ip sla monitor responder

New Member

Re: LMS 3 -ipa sla

Hi,

I am using snmp v3 read and write view on the router and the IP SLA does not see the router as possible source.

Does it support v3 or just v2

Cisco Employee

Re: LMS 3 -ipa sla

Yes, SNMPv3 is supported. It would help to see the configuration and show ver from this device.

143
Views
0
Helpful
3
Replies
CreatePlease to create content