Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 4.0 - a fault annotation

Hi,

the customer uses LMS 4.0. He annotated one fault and he cleared this fault. So this fault was cleared and it wasn't seen in the fault monitor. For now the fault is again active and the annotation for this fault is shown. So my question is: Does DFM have some annotation database where all anotation of faults are saved? When the same faults re-occur and the annotation was made for this fault in history - this fault will be displayed with this annotation??

Thank you.

Best Regards

Roman

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 4.0 - a fault annotation

The annotations are saved to a specific event.  If the event re-occurs, that event will have a new ID, so the annotation will not be there.  Annotations are saved in the dfmEpm database.

2 REPLIES
Cisco Employee

Re: LMS 4.0 - a fault annotation

The annotations are saved to a specific event.  If the event re-occurs, that event will have a new ID, so the annotation will not be there.  Annotations are saved in the dfmEpm database.

New Member

Re: LMS 4.0 - a fault annotation

thank you very much!! Roman

337
Views
0
Helpful
2
Replies
CreatePlease login to create content