As per the below link, In LMS 4.0 only network topology L2 services are supported for "7600-SIP-200" module, with cisco 7600 series routers.
My setup has cisco 7609-S series routers and the service module "7600-SIP-200" installed in it. Following are the sub modules installed in the SIP-200 card.
My doubt is will DFM manage the interfaces of this router? will I get DFM event when th POS interface of this routers goes down? for information this is a managed device in DFM and the POS interfaces managed state is set to true. However I am not getting alerts when teh POS interfaces are going down.
Even I have created a seperate group for those interfaces, applied thresholds for the interfaces and set the priority in interface group. I am still not getting any "operationally down" alert for any of my POS interface.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...