Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LMS 4.0 Fault Management Module alert doesn't show CurrentUtilization

Hi,

I would like to know if there's a way to show CurrentUtilization percentage within the messages generated by the Fault Management Module in LMS 4.0

EVENT ID                = 00008Z1

TIME                    = S

STATUS                  = Active

SEVERITY                = Critical

MANAGED OBJECT          = switch

MANAGED OBJECT TYPE     = Switches and Hubs

EVENT DESCRIPTION       = HighUtilization::Component=PORT-switch/11150 [Gi3/0/50] [---> TRUNK ];ComponentClass=Port;ComponentEventCode=1057;TrafficRate=5.2261432E7  BYPS;DuplexMode=FULLDUPLEX;UtilizationThreshold=40;MaxSpeed=1000000000;Type

NOTIFICATION ORIGINATOR = Fault Management Module

As you can see above CurrentUtilization percentage is not shown in Event Description section.

Could someone help?

Thank you!

Massimiliano.

2 REPLIES

LMS 4.0 Fault Management Module alert doesn't show CurrentUtiliz

To my knowledge nothing can be configured here.

You have to take traffic rate and max speed and do the calculation yourself

FAD! functioning as designed

Cheers,

Michel

Community Member

LMS 4.0 Fault Management Module alert doesn't show CurrentUtiliz

Hi Michel,

thanks for your reply. It was my suspicious!   

Maybe someone else can enlighten us.

Or at least let us know  if the CurrentUtilization percentage counter will come with  future  release/patch.

Ciao,

Massimiliano

444
Views
0
Helpful
2
Replies
CreatePlease to create content