Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

lms 4.0 - job scheduling and device group

Hello,

I have one question.

I scheduled a periodic job (for example the compliance check job) on week basis and I specified one user's device group for this job (for example the branch_routers group). All is working, but when new devices are added to this group (the branch_routers group), the scheduled job is not provided for these new devices:-( Is it the default behaviour? Can I change it?

It works, when I stopped this job and recreate this job again for the same group.:-( But it is not solution for my customer.

Thank you very much.

Roman

Everyone's tags (3)
1 REPLY

lms 4.0 - job scheduling and device group

When you create the job you can change the "Device Selector" to be a "Group Selector by selecting the radio button at the top of the "Device Selector" window.

The difference is the following:

- a group choosen for a job from the (default)  "Device Selector" takes all devices present in this group when the job is set up

- a group choosen from the "Group Selector" will evaluate the members of the group every time before the job runs, thus it will include every new devices in the group

456
Views
0
Helpful
1
Replies
CreatePlease to create content