Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

LMS 4.0 Performance poller Threshold Issue

I am trying to configure a performance poller threshold for CPU utilisation (5minrev).

While doing so, I am facing following issues:

1. When the poller template (CPU utilization) is selected, no MIB variable is visible for further configuration.

2. In the instance selector option, I am not able to see and select the devices to which this threshold applies.

Presently all LMS management functions are enabled except the IP SLA performance management.

Rajmohan R
Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

LMS 4.0 Performance poller Threshold Issue

Hi Rajmohan,

Are you getting any other Error under HUM  (Monitor >Performance ) ?

If no errors,Try the following steps , I hope this will help:

Steps 1:

+ Stop the Daemon Manager 

net stop crmdmgtd

Step2:
+Go to  NMSROOT\CSCOpx\databases\upm ( look for upm.log  if Exist delete
or you can take a backup as well)

Step 3: +on Command Prompt Browse to the above Directory (NMSROOT\CSCOpx\databases\upm) > dbsrv10.exe -f upm.db
Step 4: +Start the Daemon Manager : net start crmdmgtd

wait for 10-15 mins and then try to configure the Threshold and see how it works!!

Thanks

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
4 REPLIES
Cisco Employee

LMS 4.0 Performance poller Threshold Issue

Hi Rajmohan,

Are you getting any other Error under HUM  (Monitor >Performance ) ?

If no errors,Try the following steps , I hope this will help:

Steps 1:

+ Stop the Daemon Manager 

net stop crmdmgtd

Step2:
+Go to  NMSROOT\CSCOpx\databases\upm ( look for upm.log  if Exist delete
or you can take a backup as well)

Step 3: +on Command Prompt Browse to the above Directory (NMSROOT\CSCOpx\databases\upm) > dbsrv10.exe -f upm.db
Step 4: +Start the Daemon Manager : net start crmdmgtd

wait for 10-15 mins and then try to configure the Threshold and see how it works!!

Thanks

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

LMS 4.0 Performance poller Threshold Issue

Sorry, I missed to mention that LMS is installed over solaris.

Notwithstanding, I will try to carry out the suggested steps equivalent in Solaris.

Rajmohan R
Cisco Employee

LMS 4.0 Performance poller Threshold Issue

Hi,

Follow the below thread , it will help

https://supportforums.cisco.com/docs/DOC-8796

Thanks

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

LMS 4.0 Performance poller Threshold Issue

Thank you.

I am now able to configured thresholds for poller and able to select devices/instances as well.

Rajmohan R
287
Views
0
Helpful
4
Replies
CreatePlease to create content