Hi, I am going to install two new Cisco Prime LMS 4.1 servers application in a Master and Slave Deployment, and I would like to know if anybody know how many bandwidth is consumed between the servers. Thanks in advance.
I dont know if anyone would have any specific to-the-point answer on this. When you create a multiserver Master-Slave Setup for Ciscoworks ideally thier DCR are sync'd and except that there is SSO communication.
The DCR sync is quite important where all the devices and their credential information is updated to Slave LMS DCR. This is not specific to anyone as number of devices differ in each network. There is a HTTP communication between server's but that's too minimal, to consume a lot of bandwidth.
So in short no information is available now on a Bandwidth consumption between mast-slave. But it is very minimum.
**Rating Encourages contributors, and its really free. **
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...