Hi, I am going to install two new Cisco Prime LMS 4.1 servers application in a Master and Slave Deployment, and I would like to know if anybody know how many bandwidth is consumed between the servers. Thanks in advance.
I dont know if anyone would have any specific to-the-point answer on this. When you create a multiserver Master-Slave Setup for Ciscoworks ideally thier DCR are sync'd and except that there is SSO communication.
The DCR sync is quite important where all the devices and their credential information is updated to Slave LMS DCR. This is not specific to anyone as number of devices differ in each network. There is a HTTP communication between server's but that's too minimal, to consume a lot of bandwidth.
So in short no information is available now on a Bandwidth consumption between mast-slave. But it is very minimum.
**Rating Encourages contributors, and its really free. **
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.