Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LMS 4.1 Periodic Polling

Does Periodic Polling also collect or or just checks for changes and then  a Periodic Collection must be run to collect the changed configs?

i ask this because i see someone has configed both to run daily on our system.

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions

LMS 4.1 Periodic Polling

if someone would succeed in blocking SNMP, and thus preventing change detection, the weekly collection will still pick up any changes.

The polling is done on pure SNMP, where the collection uses all protocols that are allowed in RME,(TELNET, SSH, RCP, SCP, TFTP, etc)

The SYSLOG automated actions is a part of RME that listens for SYSLOG messages from the devices. You devices must be configured to send SYSLOG to the server of course. Certain messages indicate a (potential) change and trigger a collection job.

Cheers,

Michel

7 REPLIES

LMS 4.1 Periodic Polling

No, the polling can detect a change, and when it does it will launch a collection.

I does so for configuration and for inventory collection

I usually configure and validate the three mechanisms LMS has.

  • polling (daily)
  • collection (weekly)
  • automated SYSLOG action (near real time) 

Cheers,

Michel

Community Member

LMS 4.1 Periodic Polling

  why do you do a collection weekly if you run polling daily and as you say polling does a collection if it finds changes?

and what does automated SYSLOG action do?

thanks

LMS 4.1 Periodic Polling

if someone would succeed in blocking SNMP, and thus preventing change detection, the weekly collection will still pick up any changes.

The polling is done on pure SNMP, where the collection uses all protocols that are allowed in RME,(TELNET, SSH, RCP, SCP, TFTP, etc)

The SYSLOG automated actions is a part of RME that listens for SYSLOG messages from the devices. You devices must be configured to send SYSLOG to the server of course. Certain messages indicate a (potential) change and trigger a collection job.

Cheers,

Michel

Community Member

LMS 4.1 Periodic Polling

Thanks!

LMS 4.1 Periodic Polling

You are welcome  -)

Community Member

LMS 4.1 Periodic Polling

Were do you set "automated SYSLOG action (near real time)" ?

LMS 4.1 Periodic Polling

Admin -> Network -> Notification and Action Settings -> Syslog Automated Actions

Cheers,

Michel

686
Views
0
Helpful
7
Replies
CreatePlease to create content