Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 4.1 -- SwitchPort Summary Report -- Wrong total/connected Port-Count

Hi all,

we discovered a problem with accuracy of SwitchPort Summary Reports im LMS 4.1.

The amount of shown Total and connected ports in reports is greater than displayed on Device-CLI.

Has anybody else discoverd same problems with these reports? Any suggestions?

Thanks -- Lothar

------

Follwoing output is a Cat4500 with 12.2(46)SG

(1) Ports counted on Device-CLI = 56

SWITCH1>sh mod

Mod Ports Card Type                             Model             Serial No.

1    2 Supervisor IV 1000BaseX (GBIC)         WS-X4515

2    6 1000BaseX (GBIC)                       WS-X4306-GB

3   24 10/100/1000BaseT (RJ45)                WS-X4424-GB-RJ45

4    6 1000BaseX (GBIC)                       WS-X4306-GB

5   18 1000BaseX (GBIC)                       WS-X4418-GB

(2) Ports given by SwitchPort-Report = 60

/opt/CSCOpx/campus/bin/ut -cli -switchPortSummary -devices SWITCH1

Device Name,IP Address,Connected Ports,Free Ports,Free Down Ports,Total Ports

SWITCH1,10.192.209.47,50,3,7,60

(3) Several Ports a duplicate in Connected Ports Details

Port   Port Name                         Oper Status      Admin Status

Gi1/1   XXXX2001_G1/13                   UP               UP

Gi1/1   XXXX2001_G1/13                   UP               UP

Gi1/2   XXXSW153_G0/13, xxxxxxxxxxxxx    UP               UP

Gi1/2   XXXSW153_G0/13, xxxxxxxxxxxxx    UP               UP

Gi2/1   XXXSW30_G0/1, xxxxxxxxxxxxxxxx   UP               UP

Gi2/1   XXXSW30_G0/1, xxxxxxxxxxxxxxxx   UP               UP

Everyone's tags (3)
1 REPLY
New Member

LMS 4.1 -- SwitchPort Summary Report -- Wrong total/connected Po

Hi lo.mueller,

I'm facing the same problem in LMS 4.2.1, appreciate if you can share how to fix it.

Thanks.

Faizul

679
Views
0
Helpful
1
Replies
CreatePlease login to create content