After a fresh installation of Prime LMS 4.1, the time zone of the application is different than the OS time zone (MS Win2k8), and I don't found where change the time zone of the LMS through the GUI interface.
Follows attached a print screen, showing the highlighted configurations of OS time zone and the Prime LMS 4.1 time.
The time zone shown in the picture is from Venezuela (VET), but I need to configure the time zone from Brazil/East (EST).
How can I configure the correct time zone for LMS 4.1?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...