LMS 4.1 Topology fail

[s-putpong]

I have HQ and Branch router

HQ       = 2811

Branch = 2801

Connection type Freme-relay between HQ and Branch

CDP enable on interface

The Branch router show in UNCONNECTED DEVICE VIEW of Topology

please solve this problem

Thanks

[Marvin Rhoads]

Can you please check and confirm that the devices can see each other via CDP? ("show cdp neighbor" on each device.)

[s-putpong]

At HQ router show cdp can not see Branch router

At Branch router show cdp can not see HQ router

configure router

======================================

HQ

interface GigabitEthernet0/1.1000

bandwidth 512

encapsulation dot1Q 1000

ip address 10.10.191.13 255.255.255.252

======================================

Branch

interface Serial0/2/0.1 point-to-point

bandwidth 512

ip address 10.10.191.14 255.255.255.252

frame-relay interface-dlci 16 IET

=====================================

Thanks

[Marvin Rhoads]

Well if the routers themselves can't see the neighbors, LMS (which after all only queries the snmp mibs to get its information) certainly won't!

I believe you need to explicitly enable CDP on the FR-facing interfaces of your routers - a global "cdp run" command won't flow down to affect FR interface behavior.

There is also the possibility that your provider won't handle / pass the CDP layer 2 multicasts but first try explicitly adding "cdp enable" on your FR-facing interfaces.