Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LMS 4.2 (Fault Management Module)

Hi sir:

The LMS send mail alert to me , and the event is CPU High Utilization.

But the Current Utilization vaule is wrong.

How can I correct this problem?

EVENT ID                = 000M51T

TIME                    = Thu 06-Feb-2014 08:00:04 CST

STATUS                  = Active

SEVERITY                = Critical

MANAGED OBJECT          = 192.168.1.1

MANAGED OBJECT TYPE     = Security and VPN

EVENT DESCRIPTION       = HighUtilization::Component=PSR-10.10.127.64/1 [Chassis] [ASA 5505 Adaptive Security Appliance];ComponentClass=Processor;ComponentEventCode=1058;UtilizationThreshold=90;CurrentUtilization=3198607%;

NOTIFICATION ORIGINATOR = Fault Management Module

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 4.2 (Fault Management Module)

Hi Hook,

what is the threshold configured ?

Can you try to increase the Threshold and check how it works.

I have attached the Image for the same

Thanks-
Afroz
[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
5 REPLIES
Cisco Employee

Re: LMS 4.2 (Fault Management Module)

Hi Hook,

what is the threshold configured ?

Can you try to increase the Threshold and check how it works.

I have attached the Image for the same

Thanks-
Afroz
[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

LMS 4.2 (Fault Management Module)

Hi sir:

The cpu utilization value should be between 1 to 100.

According to the message, the htreshold is 90% , but LMS detect the CurrentUtilization=3198607.

Cisco Employee

LMS 4.2 (Fault Management Module)

Kindly share  your server threshold settings..

Thanks-
Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Re: LMS 4.2 (Fault Management Module)

Hi sir:

Thanks for your reply.

Is there another way to check why it detect wrong value ?

Cisco Employee

LMS 4.2 (Fault Management Module)

Hi Hook,

It could be a false alarm , you can try delete and re-add the device in DFM alone.

1.3.6.1.4.1.9.9.109.1.1.1.1.3.1  , you can do a direct SNMP WALK on this OID and see what 
values you get.

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
192
Views
0
Helpful
5
Replies