Thanks for your kind advise and given information. After successfully installed LMS 4.2 and found NW devices. I am facing an issue.
Access SW Devices are 1,2,3,4,5,6 & 7 connected to the distribute switch of A and Access SW B also connected to the distribute SW A, in middle of these switches they have Access Switch X. The Switches connected to Distribute A are showing clearly and some Access Switches connected to SW B also showing in the topology but middle of the X switch is not showing so there is no link between A&B. But when I do SNMP walk on that X devices ran successfully. I cant see in the device list and in topology view.
I have attached the picture for reference. Please advise how can I bring this device in to topology and see the link correctly.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.