I have just finished installing the LMS 4.2 (Fresh Install) on VM ESXi 5.1. I followed the setup guide and that the installation process is finished perfectly. I can not even get into the main page (to type the login credentials) and just only accepting the certificate, then a page was shown with the following,
You don't have permission to access / on this server.
Additionally, a 403 Forbidden error was encountered while trying to use an ErrorDocument to handle the request.
Is there any idea that I can get from? Have you ever been experiencing similar problems and is there any solutions? I am stuck at this stage and extremely frustrated because I followed nearly everything according to Cisco's recommendations.
Thanks for your reply, and I have actually went thru it all.
However, I managed to solve the problems finally with all the certs deleted, manager daemon stopped, SSL disabled and then enabled the SSL again (It will automatically ask you to re-generate the cert with credentials), started the manager daemon and then I can login and work perfectly.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.