12-01-2006 06:10 AM
Hi,
I upgraded LMS to 2.5.1 but after that, I am not seeing one of my Cisco 3825 routers and two of my edge switches Cisco 3560 is shown with the "?" mark on gren icons.
i have checked the snmp community but couldn't find what might have caused this.
any help is greatly appreciated.
Thx,
Masood
12-01-2006 06:27 AM
What are the sysObjectID's of the 3560's?
If you add the 3825 as a seed device does it show up? If you run the command show cdp neigh on a device connected to the 3825 does it appear there?
12-01-2006 08:28 AM
Hi and thanks for responding.
the Cisco 3825 has been defined as one of the seed devices in LMS. I have two Cisco 3825 at my network edge, one active an dthe aother one stand by, i see the stand by router in CM but not the active one which is a seed device.
on the 3560 edge switches that are shown with green Icons with the "?" i don't see none of the routers with the sh cdp neigh command.
Thx,
Masood
12-01-2006 08:48 AM
how can I check tyhe ObjectIDs on the 3560s?
I enabled the cdp on that router and I can see in the CM now.
I still see th etwo CAT 3560s in green icons with the "?" on them
Thx,
Masood
12-01-2006 10:52 AM
You can use the SNMP Walk tool in CiscoWorks Device Center to poll the sysObjectID object.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide