Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

LMS Authentication Failure

This was working up until last week but now when I try to log into LMS I just get an authentication failure message.

LMS is configured to use ACS for access but ACS is not writing any information in the log files for the LMS server. So I can only assume that there is a problem with the link to ACS

How can I gain access to LMS and allow me to switch the system to a non-acs mode so I can access the server without first having logged in?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS Authentication Failure

From the CLI, run the command:

NMSROOT/bin/perl NMSROOT/bin/ResetLoginModule.pl

You will then be able to login using local authentication and authorization.

1 REPLY
Cisco Employee

Re: LMS Authentication Failure

From the CLI, run the command:

NMSROOT/bin/perl NMSROOT/bin/ResetLoginModule.pl

You will then be able to login using local authentication and authorization.

148
Views
0
Helpful
1
Replies
CreatePlease to create content