Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS cannot fetch vlan.dat

Hi,

we have an LMS and we have some devices in different networks. Devices are 38xx, 28xx, etc.

LMS can only fetch VLAN config from devices located in the same subnet that the LMS is.

In the rest of devices, LMS can fetch running and startup configs but not vlan.dat.

It's not a credentials problem. We think it's the internal method used for recovering this file.

We need to know how is this file retrieved (via TFTP, is it send by the router...) because there is a network between LMS and these devices administered by other group and we have to tell them which ports must be opened.

Many thanks.

3 REPLIES
Cisco Employee

Re: LMS cannot fetch vlan.dat

Vlan.dat is fetched by teleting or SSHing to the device, then performing, "copy flash:vlan.dat tftp:". This is the only way vlan.dat can be archived.

New Member

Re: LMS cannot fetch vlan.dat

Hi,

this is the output from the router if I execute that command:

%Error opening tftp://x.x.x.x/vlan.dat (time out)

I think that:

- it's not a route problem nor a tftp server permission problem: because LMS can retrieve the running and startup config perfectly.

- it's a problem with ports: am I right? If so, what ports and where do I have to open?

- perhaps an access-list...

Thank you very very much.

Cisco Employee

Re: LMS cannot fetch vlan.dat

You have to open udp/69 between the device and the server. The device will make a write request to udp/69, then the TFTP will happen over high UDP ports.

195
Views
5
Helpful
3
Replies