Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS : Config Collection “Partional Successful” message

Dear All

Szenario:We have 2 CW Server one CWLMS2.6 and one CWLMS3.1 based on Solaris.

For CM3.1 I have the following problem:

If I make a Config Collection for a specific device or the entiry network I get a lot of “Partional Successful” Status messages. A lot of this messages are “VLAN RUNNING Config fetch failed for ….. Cause: VLAN Config is not supported using TFTP”

The startup and runnig Config is collected without problems.

The Transport Setting on both systems are Telnet, ssh, tftp.

CW2.6 has no failure during the config fetch.

What is wrong?

Thanks

2 REPLIES
Blue

Re: LMS : Config Collection “Partional Successful” mes

New Member

Re: LMS : Config Collection “Partional Successful” mes

We tested all required ports, but the results are fine - all ports are open. (Of course the behavior doesn't change.) Do you have an other suggestion?

Thanks for your help.

123
Views
0
Helpful
2
Replies