Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

LMS Configuration

Hi,

Please can somebody help me in Cisco Works (LMS)

I have install the all this service in LMS2.5

1. Common Services

2. Cisco View

3. Resource Manager Essentials

4. Campus Manager

5. Device Fault Manager

6. Internetwork Performance Monitor

and now in my network i have one pix firewall and one switch ....

So please help me that how i can manage this device in LMS 2.5

My EMail ID is linux_ccnp@yahoo.co.in

Regards,

2 REPLIES
Silver

Re: LMS Configuration

Hello Shailesh,

start reading here:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000_b/lms/index.htm

This will extend your knowledge to manage these two devices.

Best regards,

Frank

New Member

Re: LMS Configuration

Starting with version 2.5 Cisco Works LMS uses a common database for all devices.

There are several methods of entering devices

1) Manually add them

2) Use auto discovery (remember to set a seed device - oh an this works best if you have CDP enabled)

#1) To manually add a device, log into Cisco works, go to Common Services => Device and Credentials => Device Management. Click the add button and input the information about your devices. Once completed you more then likely want to inventory the device to get information about it into your repository. To do this go to (main window) RME => Config Management => Archive Management. In the window that pops up choose "Sync Archive", pick the devices, give it a description and hit run.

#2) Go to Campus Manager => Administration. New window go to Admin => Device Discovery. You should get if from there but it’s a bit slower the doing #1.

"Quick Start Guide for LAN Management Solution 2.5" link can be found at

http://www.cisco.com/en/US/products/sw/cscowork/ps2425/products_quick_start09186a008036dfa9.html

Andy

188
Views
0
Helpful
2
Replies
CreatePlease to create content