New LMS install and I'm trying to add devices, or at least a seed device. Any native IOS 6500 I add fails on the SNMPv2c RW string although it succeeds on the RO. CatOS 6500 works fine. I can add the CatOS switch to RME too.
I've tried deleting and re-entering the snmp strings, deleting and re-entering the strings in DCA, deleting and re-adding the devices. I can snmpwalk the RW string from another computer as well.
The key being that you can walk the RW string from ANOTHER COMPUTER. What about from the LMS server using the SNMP Walk tool in Device Center? I'm betting that if you look at the running config on these IOS switches, you will see an access-list applied to the RW community string, and your LMS server is not allowed by that ACL.
Pretty sure we've determined it's a problem with the server itself. Using GetIF reponses from either the RO or the RW string are intermittent. I also can't get a working SSH connection from Putty on the same server. We're rebuilding it.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.