Discovery can be configured under Common Services > Device and Credentials > Device Discovery. You have a choice of a variety of protocols. The two most commonly used are CDP and ping sweeps (in that order). Just step through the Discovery configuration wizard, and fill out the required information. When complete start your Discovery. All devices which are SNMP reachable will automatically be added to DCR when Discovery completes.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...