Loopback0 is up, line protocol is up Hardware is Loopback Internet address is xx.x.x.x/32
I'm also seeing problems with chassis cards appearing down when they aren't.
I'm not sure whether the /137 in the alarm is an snmp ifindex or not but if it is, I think it's mixed up:
sh snmp mib ifmib ifindex | include Loop Loopback0: Ifindex = 155
sh snmp mib ifmib ifindex | include 136 GigabitEthernetX/Y: Ifindex = 136
sho int gX/Y GigabitEthernetX/Y is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet Port, address is xxxx.xxxx.xxxx (bia xxxx.xxxx.xxxx) MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.