Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

LMS MIB

Hi,

Is there a way we an creat MIBs and we can link it with CiscoWorks to monitor the information it will provide?

-Thanks

1 REPLY
Cisco Employee

Re: LMS MIB

If you have the Health and Utilization Monitor add-on installed, you can load MIBs into it, and then create custom templates and pollers to monitor required OID values. In order to load MIBs into HUM you must first load all of the required MIBs listed in the target MIB's IMPORT clause. This must be done recursively for all dependencies.

The MIB load interface can be found under HUM > Admin > Load MIB.

365
Views
5
Helpful
1
Replies
CreatePlease to create content