LMS multiple device access reconfiguration from telnet to ssh
By using RME report one can check configuration and find out if ssh is enabled and used. My question is if I can get a report on multiple devices and their SW version in regard to crypto ssh feature set ? Can I retreive ssh capable/not capable SW report automaticcaly ? What is the best practise scenario ?
Re: LMS multiple device access reconfiguration from telnet to ss
Inventory collection stores the information about the IOS running on the device. So I think in your case, you need to genrate the custom report which gives you the information about the IOS running on the devices.
If this is the case, You can create your custom template from RME > Reports > Custom Report Template > Create > Inventory > provide the name to the template >
From the Inventory group > select Image > select the Attributes according to your requirements ( I guess you need Feature and Image ) > Finish.
Now run this template on required devices from RME > Report Generator > Select Inventory > and now select your template to run > Finish.
Note :- Kindly check option ==> Attributes in multiple table at the bottom of the job page.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...