LMS Notification message for power of a switch module
I'd like to know how to deal with this alert: what exactly does this mean: here are some of the output from the show commands i have done on the switch. please do advice if i have missed something here.
IT-swi-in-pjtc-1#sh environment status power-supply 1 power-supply 1: power-supply 1 fan-fail: OK power-supply 1 power-output-fail: OK IT-swi-in-pjtc-1#sh environment status power-supply 2 power-supply 2: power-supply 2 fan-fail: OK power-supply 2 power-input: AC high power-supply 2 power-output-fail: OK
Re: LMS Notification message for power of a switch module
This event has nothing to do with the show commands you collected. This event says that the CPU of module 8 of device IT-swi-in-pjtc-1 was at 100%. It has nothing to do with any environmental problem. I'm not sure what module 8 is exactly, but something is taking up all of its CPU time. You should identify what that is, and see if the process or task is misbehaving.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.