Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LMS Prime 4.2.2 Device Configuration Change Report

I would like to configure LMS to generate an email every time a configuration change is made by ether CLI or a CW Job. I haven’t had much luck making this happen. If anyone could post some steps or a link to a document that would be great.

Thank you for any assistance you can provide.

Everyone's tags (3)
1 REPLY
Cisco Employee

LMS Prime 4.2.2 Device Configuration Change Report

Hi Ray ,

You can use the feature called Change Audit to achive your Goal:

Change Audit clients are RME applications that  record change  information. Applications, such as Software Management,  send messages to  Change Audit when they make a change to the network,  for example,  uploading a new Cisco IOS image.

For more information , you can check the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.2/user/guide/chgaud.html#wp1031857

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.2/user/guide/chgaud.html#wp1034685

You can also create AUTOMATED Action bases on SYSLOGS to track or email the chnages to you :

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.2/user/guide/syslog.html#wp1211314

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
432
Views
0
Helpful
1
Replies
CreatePlease to create content