cisco WS-C2960-48PST-L (PowerPC405) processor (revision D0) with 61440K/4088K bytes of memory. Cisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version 12.2(46)SE, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2008 by Cisco Systems, Inc. Compiled Thu 21-Aug-08 15:59 by nachen Image text-base: 0x00003000, data-base: 0x01200000
ROM: Bootstrap program is C2960 boot loader BOOTLDR: C2960 Boot Loader (C2960-HBOOT-M) Version 12.2(46r)SE2, RELEASE SOFTWARE (fc1)
System returned to ROM by power-on System image file is "flash:/c2960-lanbasek9-mz.122-46.SE/c2960-lanbasek9-mz.122-46.SE.bin"
Last reset from power-on 2 Virtual Ethernet interfaces 48 FastEthernet interfaces 4 Gigabit Ethernet interfaces The password-recovery mechanism is enabled.
64K bytes of flash-simulated non-volatile configuration memory.
Motherboard assembly number : 73-11882-08 Power supply part number : 341-0266-03 Motherboard serial number : Power supply serial number : DCA1424H4NF Model revision number : D0 Motherboard revision number : A0 Model number : WS-C2960-48PST-L System serial number : Top Assembly Part Number : 800-30874-04 Top Assembly Revision Number : B0 Version ID : V03 CLEI Code Number : COMC400ARA Hardware Board Revision Number : 0x01
Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 1 52 WS-C2960-48PST-L 12.2(46)SE C2960-LANBASEK9-M
Check your version of the RME Cat2960 package. The latest is 6.4 and support for this 2960 switch is available. If you do not have, go to Common Services > Software Center > Device Update and download and install all available updates for Common Services and RME. Once that is done, RME will be able to fully manage these switches.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...