Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LMS2.5 Alert Filtering

Is it possible to get CiscoWorks (LMS2.5) to ignore/discard certain alerts say between 8pm and 7am.

For security reasons the majority of our network is 'cut off' each night but obvisouly CiscoWorks sees this as a problem and reports Active then Cleared Reachability.

Thanks

1 REPLY
Silver

Re: LMS2.5 Alert Filtering

not sure, if you can filter the alerts, based on time, but filters are available that allow you to manipulate the Alerts and Activities display to show alerts based on their severity, status, and originating device type. check out the url below :

http://www.cisco.com/en/US/products/sw/cscowork/ps2421/products_user_guide_chapter09186a0080296c29.html

87
Views
0
Helpful
1
Replies