hello, wondering what is the best way to be notified and eventually fire a script when a new device is discovered? I can see the RME Change Audit Automated Action has email and script actions. Unsure what the Application, Category and Mode settings refer to. Which combination gives me new devices only?
If I call a script, what parameters (if any) are passed into it?
Unfortunately, this is not possible. You cannot trigger an action when a new device is added to DCR
Instead, you would need to write some code that uses dcrcli (for example) to continually poll the device list, and check for changes. When you find one, you can then pull out the device attributes, and fire off your event.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...