Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LMS3.0 how to push the configuration to the new switches

Hi,

I have a question on how we use LMS3.0 to push the configuration to new switches?

may i know the guide line for it, urgent!

Thank a lot

-Gilbert

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: LMS3.0 how to push the configuration to the new switches

Here is a link to the rme userguide. You need to go to RME\config mgmt\Net config

This assumed you have all your devices currently being managed by LMS/rme

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.1/user/guide/RME41_UG.html

3 REPLIES
Silver

Re: LMS3.0 how to push the configuration to the new switches

You have to have minimal networking configured on them such as an IP address, snmp communities, tftp/scp and telnet/ssh in order to do this. Then its just a matter of creating a netconfig job to modify whatever you want.

New Member

Re: LMS3.0 how to push the configuration to the new switches

Hi,

May i have reference link which i can refer?

thanks a lot

Gilbert

New Member

Re: LMS3.0 how to push the configuration to the new switches

Here is a link to the rme userguide. You need to go to RME\config mgmt\Net config

This assumed you have all your devices currently being managed by LMS/rme

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.1/user/guide/RME41_UG.html

130
Views
0
Helpful
3
Replies