Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

LMS4 Device sensed, but collection failed, Cat 4500

This is a WS-C4510R+E with a Sup 7-E running 03.02.02.SG enterprise.

I increased SNMP timeout to 10 seconds to no avail.

The IC_Server.log is attached. Any ideas?

-Jeff

Everyone's tags (6)
5 REPLIES
New Member

LMS4 Device sensed, but collection failed, Cat 4500

I guess I should have specified that the message is received during inventory collection. 

New Member

LMS4 Device sensed, but collection failed, Cat 4500

I guess I should also have specified this is LMS 4.1 on W2k8 R2

Cisco Employee

Re: LMS4 Device sensed, but collection failed, Cat 4500

Hi Jeff,

Try to increase the timeout more for snmp, say 20 and enable debug to ICServer and run the job again.

Repost the IC_server.log than if issue persist and also share the IOS running on device.

-Thanks Vinod **Rating Encourages contributors, and its really free. **
New Member

Re: LMS4 Device sensed, but collection failed, Cat 4500

Thanks for the Reply Vinod.

This is a 4510R+E with a Sup 7-E running IOS XE 3.2.2 SG. As far as I can tell this is based on IOS 15.0(2).

Upped timeout to 20 seconds, same results.  IC_Server.log is attached.

New Member

LMS4 Device sensed, but collection failed, Cat 4500

I had the same issue with default snmp timeout value. After I have changed the snmp timeout to 30 sec, the LMS successfully collected inventory details from 4510R+E.

843
Views
0
Helpful
5
Replies
CreatePlease to create content