I have setup logging on in my router. I have entered the logging buffered <size> but for some reason the show log is not displaying all the logs. This router is a 2600 series acting as a H323 gateway. I have another one where the logs are enabled and I can see all the calls that connect in the logs.
One possible explanation for this symptom could be the setting of severity level for logging buffered. You do not indicate what severity level you have set and it might be possible that logging is set for a severity level that is higher than the messages that you are looking for.
It would help if you would post the first screen full of output from the show log command. This will show what logging and what severity level has been configured. It would also help if you could tell us what kind of messages are not showing in the logs.
Thank you for posting the additional information. It does show that the issue is not the setting of the severity level. The logging buffer is set to level debugging which should include all messages sent to syslog.
I do note that only 1 message has been sent to the logging buffer since you enabled logging buffered. Has there been activity on the router since you enabled logging buffered that should have generated log messages?
Is it possible that there is some difference in configuration between this router and the other h323 gateway and that this router is not generating the same syslog messages?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.