09-24-2008 11:38 AM
Is "mac address-table notification mac-move" needed for Dynamic Updates to work properly in Campus Manager (LMS 3.1)?
Solved! Go to Solution.
09-24-2008 01:26 PM
The only traps Campus Manager processes are Dynamic UT are cmnMacChangedNotification traps. Therefore, all you need to configure are:
(Under the interfaces)
snmp trap mac-notification change added
snmp trap mac-notification change removed
(Global)
mac address-table notification change
mac address-table notification change interval 15
snmp-server enable traps mac-notification change
snmp-server host HOST COMMUNITY udp-port 1431 mac-notification
09-24-2008 01:26 PM
The only traps Campus Manager processes are Dynamic UT are cmnMacChangedNotification traps. Therefore, all you need to configure are:
(Under the interfaces)
snmp trap mac-notification change added
snmp trap mac-notification change removed
(Global)
mac address-table notification change
mac address-table notification change interval 15
snmp-server enable traps mac-notification change
snmp-server host HOST COMMUNITY udp-port 1431 mac-notification
09-25-2008 05:42 AM
One question regarding this when applied to 6500s. I've noticed that the "mac-address-table notification change" and the "mac address-table notification change interval 15" does not work.
Was this command deprecated on the 6500s (tried this on 12.2(18)SXF14)? If so, what's the equivalent replacement?
09-25-2008 06:06 AM
The change traps are not supported on the 6500s running IOS.
09-25-2008 06:16 AM
So would that mean, at least for now, that Dynamic User Tracking will not work for 6500s running IOS?
09-25-2008 08:51 AM
Correct. My best guess on why this is the case is that 6500s are typically not use at the access layer.
Switches which can support Dynamic UT are 3560s, 3550s, 3750s, XLs, 2970s, 2960s, ME3400s, 6Ks running CatOS, and 4Ks running CatOS.
09-25-2008 09:45 AM
Thanks for the list. I'm a bit surprised by this, but I'll take it up through our account manager.
10-08-2008 12:47 PM
I've found that the "mac-address-table notification change" command is available in 12.2(33)SXH for the 6500s (http://www.cisco.com/en/US/docs/ios/lanswitch/command/reference/lsw_m1.html#wp1012601).
Are there future plans for LMS to support Dynamic UT for 6Ks running IOS?
10-08-2008 12:49 PM
If the trap is there, UT will support it. It just doesn't have the ability to configure it right now. However, if you manually add the commands to the switch, UT won't care that the traps are coming from a 6500 running IOS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: